PRi FLEX 2K

PRi FLEX 2K can be applied to new or old concrete structures that are structurally sound and strong.

• Basement retaining walls.
• Pile Heads.
• Structural surfaces of cellars.
• Concrete roof slabs, floors, balcony floor slabs.
• Water tanks and swimming pools.
• Bridge decks.
• Canals and dam walls.
• Structural surfaces of dykes.
• Suitable for steam room waterproofing.
• Sewage treatment plants.
• Waterproof coating (bottom coat) for marble, granite and other natural stones.
• For special applications such as areas where more thick plaster application is needed.

• Flexibility
  Provides a flexible & low permeable coating.
• Water permeability
  Excellent resistance to ingress of water.
• Waterproof
  Waterproof for concrete structures.
• Slip resistance
  Provides slip resistant coating.
• Adhesion
  Excellent adhesion to concrete, natural stone.
• Diffusion
  Excellent resistance to chloride ion diffusion and carbon dioxide.
• Low temperature resistant
  Resistant to freeze-thaw cycles and de-icing salts.
• Carbonation
  Prevents carbonation of cement concrete.

Surface Preparation

• The surface must be strong & free from dirt, dust & loose particles. Thoroughly wire brush he surface & clean the dust by air
  compressor or wash the surface with water.
• Oil & grease must be removed using degreasing solvents.
• Any damaged surface must be repaired by using polymer modified repair mortar.

Mixing

Shake well the liquid component to a homogeneous milky colour, before mixing transfer entire quantity of liquid component
into a suitable clean mixing vessel, gradually start addition of powder component under constant mixing with a stirrer using a
pneumatic or electric power tool (1kw) at slow speed at 250-300 rpm for 3-5 minutes to a homogeneous & uniform free flowing
slurry.

Binding Coverage
Apply slurry coat of mixed material for two coats at a coverage rate of 1.5 kg/m² over the set concrete slab by a masonry brush
or appropriate power spray equipment.
Concrete slabs or roof slabs
Two coat of mixed slurry to be applied to the set concrete 1.5 kg/m² by a masonry brush, roller or appropriate power spray
equipment.
Pile Heads
-Two coats of mixed slurry to be applied on to the pile head @ 0.75 kg/m² first coat and 1.25 to 1.5 kg/m².
-Second coat either by a masonry brush or appropriate power spray equipment.
Water tanks and Swimming Pools
– Two coats of PRiBOND’S PRi FLEX 2K applied @ 1.5 kg/m2 each coat by a masonry brush or an appropriate power spray
equipment.
– All applications where two coats is specified, the second coat shall be applied when the first coat is completely dried.
– The treated area should be protected from direct sunlight and to be damp cured by covering with damp hessian or similar.
Marbles / Stones
It is recommended to apply one coat at the bottom side of the marble @ 1.5mm thick at a coverage of approximately 1.8 or
2kg/m

• • Mix the entire quantity of both the components at one go.
• Do not use powder with the liquid other than the powder accompanied with liquid, it will affect the Performance.
• Do not add water and cement for dilution.
• Do not flood or overexpose the treated surface to water until it is completely cured.